0:00
Welcome guys, today I am with Blackview AN80 and I'm going to show you how you can apply
0:10
tempered glass on this smartphone. So for the first you have to remember to prepare a good source of light to see every mess that
0:17
you have on your screen, like the fingerprints, other greasy marks and for example the pieces
0:24
of the dust. So right now I'm gonna zoom in to show you how it looks a little bit closer, ok like that
0:34
Another step will be about opening the box with your tempered glass
0:39
So inside there will be glass and also you will get these two wipes
0:46
As you can see we got the wet and the dry, so at the first we are going to start from
0:50
this one. Ok so as you can see here we have this wet wipe and with this one we have to simply clean
1:00
the screen and remove all of this pieces of the dust and other stuff from the screen
1:14
So you have to remember to reach every corner and edge and after you finish it will look
1:20
like that. So another step, the dry wipe, it's right here, so you have to also open it and then
1:30
remove all of this wet marks from your screen
1:41
Ok and when you finish you are able to remove this foil from this bottom part of the tempered glass
1:48
So you can grab this sticker and gently pull it towards you
1:54
As you can see it goes very easy. And then hold this glass with your four fingers like that and I can recommend you to start
2:04
from this part, from the upper section of the phone screen. So keep holding the bottom part, put the upper section of the screen, of the tempered glass
2:12
on your screen. And try to pull it correctly for the both edges
2:19
I think that in my case it's well placed so I'm gonna put the finger right here, keep
2:26
holding and then try to do the same at the bottom. Ok I think it's fine so I'm gonna put this bottom part and right now you can swipe up
2:38
with your finger and as you can see right now it goes almost automatically but you can
2:47
make it a little bit faster. And for example as you can see right here we have to manually press it to get it stick
3:03
to our display. You are also able to install this glass on your foil
3:12
Ok as you can see we got here the bubbles so take a look how easily we can remove them
3:16
Just put your fingernail right here in the corner, raise this glass a little bit until
3:23
the bubbles disappear. And right now put it and swipe with your finger
3:33
As you can see there it is, we can make it like that
3:37
So right now we can turn on the phone and at this time we can also just press to get
3:47
it stick better to remove this glue marks that you can find under the glass so when
3:56
you press on them they will disappear
4:08
Ok and as you can see right now we successfully did it
4:13
Right now we are able to for example set up our phone
4:19
And as you can see there is no any problem with the touch interaction, everything works
4:23
fine even with two protection because I installed this glass on foil, on the factory installed
4:29
foil, everything is fine. So yeah that's all for the Blackview A90
4:36
If you find this video helpful remember to leave a like, comment and subscribe
